Design Of Generic Vedic ALU Using Reversible LogicID: 4055 Abstract :Power Dissipation Is A First-order Constraint In Digital System Design, And Logically Irreversible Computation Carries A Fundamental Lower Bound On Energy Per Erased Bit. Reversible Logic, In Which Every Output Vector Identifies A Unique Input Vector, Is One Route To Circuits That Avoid This Bound In Principle. This Paper Presents The Design, Verilog Implementation And Verification Of A Parameterized Generic Arithmetic Logic Unit (ALU) Built From Reversible Gates Around An Urdhva Tiryakbhyam (Vedic) Multiplier. The ALU Combines A Ripple-carry Adder/subtractor Made Of HNG Gates, A Recursive N×N Vedic Multiplier Whose 2×2 Base Block Uses BVF, BME And Peres Gates, A Logic Unit, And A Three-way Output Multiplexer Made Of BHA Gates. The Architecture And Gate Library Follow A Published Design; The Implementation Reconciles An Inconsistent Control Encoding And Uses A Second Peres Gate In Place Of A CNOT Stage In The 2×2 Block. A Self-checking Testbench On A 64-bit Instance Completed 928 Checks With No Mismatches, And The Multiplier Was Verified Exhaustively Up To 8×8 Operands. Mapping To Xilinx 7-series LUTs Gives 41 To 11,430 LUTs For 4- To 64-bit Operands, And The Reversible Gate Count Follows G(N)=2.5N2 -2.5N For The Multiplier. A Gate-level Audit Also Shows That The BME Gate, As Coded, Is Not Bijective. Timing, Power And A Like-for-like Comparison With The Baseline Remain Future Work. |
Published:16-11-2026 Issue:Vol. 26 No. 11 (2026) Page Nos:129-134 Section:Articles License:This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License. How to CiteA. Jayasilpa,Smt. Dr. G. Jyoshna, Design of Generic Vedic ALU Using Reversible Logic , 2026, International Journal of Engineering Sciences and Advanced Technology, 26(11), Page 129-134, ISSN No: 2250-3676. |